We designed this clip-on grid to greatly reduce the spill on the Aputure MC mini LED. Grids are aligned so they do not block any LED. Has approximately 60-degree beam angle. Does not block vents or controls and has an indent to still allow you to use the threaded mount.
• Custom designed by Bioluminous LLC, not manufactured by Aputure
• Clip-on design
• Made of extremely strong polycarbonate
• Heat-resistant, will not deform like typical 3D prints made from PLA
• Does not block vents or controls
• Allows use of tripod mount
• Fits in standard factory case with grid attached
• Made in and ships from Seattle USA
• Aputure MC light is not included
We design and produce hundreds of parts for the film industry, aviation and general consumer electronics. Take a look at our other listings!
